Cue Care
Never leave your cue in a vehicle. Warping can start within hours.
Keep your cue out of direct heat and damp areas.
Store your cue in a good quality case, laid flat, for protection. Check out Instroke™ cases for a large selection.
Store the butt end of your cue in your case with its bumper end down, this eliminates pressure on the joint pin.
Never lean your cue against the wall by the tip/ ferrule.
Cue Tip/Ferrule
The cue tip has been scuffed and shaped to the nickel radius. Be sure to shape it to your own requirements.
Use a scuff cube or tip tool to groom the cue tip before play.
The tip should be replaced when the thickness is that of a dime.
The ferrule should require little to no maintenance. other than cleaning and inspection, but if you have damage
Cue Shaft
Be sure your hands are clean when handling your cue to elimnate extra dirt and oil build up.
Wipe the cue with a lint free cloth to keep it clean after playing.
There are several safe products available to help clean and condition the shaft, we sell a few.
Avoid products that contain wax, oils, silicone etc. They can soften the wood and damage the shaft.
Never use sandpaper or other abrasive materials on your cue shaft.
Refer to a qualified cue repair specialist to remove dents, never “roll” them out.
From time-to-time remove build up with a damp cloth, drying immediately after.
Cue Joint
Use your joint protectors! They protect from moisture and damage to the joint pin if the cue is dropped.
Inspect and clean the pin and bearing surfaces of the shaft and joint collar regularly.
If you find damage to the joint, seek a qualified cue repair person.
Cue Butt
Never tap your cue butt on the floor or table. Your butt plate is tightly fitted and could crack.
Your cue has a polyurethane automotive clear finish; It’s acceptable to wax from time-to-time.
Leather wrap can be cared for with regular shoe polish and general leather cleaning products.
Irish linen wrap can be cleaned by a qualified cue repair specialist.